Full video walkthrough guide
Pick up the Blueprint 1, 2 & 3, Note 1, stun gun & screwdriver grip from the table.
On the floor near the robots, pick up note 2 &3.
Check the machine and you will see something shining. Pick up the screwdriver head and combine it with the screwdriver grip to get screwdriver.
On the other machine, pick up the wire cutter.
Use the stun gun on the volt contactor and follow the note 1 on the order to activate the robots. (From left to right 1 > 5 > 4 > 2 > 6 > 3)
Speak to the 3 robots. On the bomb machine, press the center grey button to bring up the detonation box.
Before you proceed, check note 2 & 3 to know the color for each robot.
For the first circuit, follow the blueprint 1 and cut red. Remove the screw driver holding the fuse first then the remaining.
For the 2nd board, you need to make sure the hammer does not hit the pendulum, otherwise you will be brought to a minigame where you have to avoid the red & blue balls from colliding. The order of the screws are as follows (please check video walkthrough if you are unsure):
- Right Top
- Right Mid
- Left Bottom
- Left Top
- Remaining in any order
- 4 sides
For the next circuit, follow the blueprint 2 and cut blue. Remove the screw driver holding the fuse first then the remaining.
For the last circuit, the blueprint 3 is too blurry but Alex’s note will tell you to Cut Betty. Cut the red wire.
Sharbit Guide 